60leds/m Black PCB Addressable White HD107S 3000K Pixel LED Strip lights

HD107s pixel LED chip adopt Newstar’s IC to keep long lifespan, top quality/most stable/fastest run speed.

What is HD107S LEDs?
Upgrade of APA107, Newstar is the original IC factory, it is same protocol with APA102, same PCB, same controller, but performance is much better than APA102, also with much better price.
PWM refresh rate: 27kHz, Oscillator frequency: 40Mhz.

  • Description
  • Inquiry

60leds/m HD107S 3000K Pixel LED Strip lights Specification (HD107S-60W-5V):

1, IC Model: Newstar’s 107S IC chip;
2, LED Type: 5050 SMD LED;
3, LED Quantity: 60LEDs/m, every LED is cuttable, each LED is separately controlled;
4, Pixels Qty: 60 Pixels/m;
5, Pitch: 60LEDs—16.67mm(1000/60);
6, Power: 60LEDs—18w/m;
7, IP Grade:
> IP20 non-waterproof;
> IP65 Waterproof in silicon coating;
> IP67 Waterproof in silicon tube;
8, FPCB color: White PCB / Black PCB;
9, FPCB board Dimensions: 10mm/12mm width, 2.0mm thickness;
10, Emitting Color: Warm white 3000K, can be adjusted;
11, Standard Operating Voltage: DC 5V input;
12, Cuttable: Every LED can be cuttable.
13, Package: in anti-static bag, IP20 IP65 with 3M adhensive tape on the back (IP67 without 3M adhensive) each strip with one free male connector for connector
14, View angle: 120 degree;
15, Gray Scale: 256;
16, Warranty: 3 years;
17, Certification: CE & RoHS;

CMOS process,low voltage ,low consumption
Synchronization of two-lane
Choose positive output or negative RGB three-color LED output
8 bit(256 level) color set ,5bit(32 level) brightness adjustment
Build-20ma constant current output
With self-detection signal build in support for continuous oscillation PWM
output ,can be maintained static screen

  HD107S White Addressable LED Strips are Applicable to people who would like to pursue fashion and romance, for individual creativity and the new apartment decoration, as its soft, light and thin features very suitable for DIY personal space.
> LED programmable digital screen / Hotels decoration lighting / Backlighting decoration / Concealed lighting / Cove decoration / led wall, advertising board / Outdoor advertising signs / Hotel, KTV, bars / Wedding party lighting, 

How to connect and control: 
The HD107S white led strip has 4 wires for sending data – one V+ pin, one GND pin and one data pin. That means you need 4 pins to control strip. Because the data is seperated, you can use any processor speed or type to control these strips. an addressable Warm white LED strip is a long flexible strand of LEDs each of which can be individually set to a certain color (hence: addressable). You can use any processor speed or type to control these strips, you can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any ‘raw’ microcontrollers/microprocessors to control the strip.
This strip comes as a single full meter with a 4-pin JST SM connector on each end. Every LEDs segment can be cut. Solder to the 0.1″ copper pads and you’re good to go.you can also connect strips together to make them longer. To power this strip, you need 5V power supply.
If need us suggest SPI controller or other software, please contact us.


Contact Us